Wi-Fi, après la mise a jour1.1.0 rien ne marche plus ,avec la version1.0.2 tout alles tres bien
Besoin d'aide pour connecter des caméra au réseau Wi-Fi, après la mise a jour 1.1.0 rien ne marche plus , avec la version firmware 1.0.2 tout allés très bien
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, thanks for the quick reply.
It seems like you have contacted the local technical support before, and now the case has been escalated to the senior engineer for further assistance.
Please check the email later for more suggestions.
Best regards.
Update:
A beta firmware is ready for Deco BE25_V1_1.1.0 to improve the network stability, especially for smart home devices.
If you happen to run into a similar issue," 2.4GHz IoT devices frequently disconnected from Wi-Fi, lose connectivity, or become offline/unresponsive", please leave me a message to test the beta firmware.
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
Hi, welcome to the community.
Is the LED on Deco BE25 still solid green?
Can I have the model number of the smart WiFi cameras?
Would there be any error message when it failed to connect to Deco?
Here are some suggestions for your reference:
- Enable IoT Network and set the "Security" to "WPA2 only"
- Set the WiFi channel under Main WiFi>2.4Ghz band>2.4GHz channels settings> channel 11 and channel width 20MHz
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
Hi, DAVID
thanks for the reply
Is the LED on Deco BE25 still solid green? YES
Can I have the model number of the smart WiFi cameras? Dahua P5AS-PV
Would there be any error message when it failed to connect to Deco? Nope
Here are some suggestions for your reference:
- Enable IoT Network and set the "Security" to "WPA2 only" Done and not working
- Set the WiFi channel under Main WiFi>2.4Ghz band>2.4GHz channels settings> Done same result
channel 11 and channel width 20MHz ??? I can change from 160 to 80 MHz, no effect, the channel I can't change the channel, but in the web interface it is set to channel 3
After the firmware 1.1.0 update, nothing works anymore. With the firmware version 1.0.2, everything is was fine,
I just need to rollback the firmware go back to 1.0.2 or something like that
I have use BE25's in like 7 location like 28 BE25 Total for the past two years all good, until 1.1.2
- Thanks
- Copy Link
- Report Inappropriate Content
Hi, thanks for the quick reply.
It seems like you have contacted the local technical support before, and now the case has been escalated to the senior engineer for further assistance.
Please check the email later for more suggestions.
Best regards.
Update:
A beta firmware is ready for Deco BE25_V1_1.1.0 to improve the network stability, especially for smart home devices.
If you happen to run into a similar issue," 2.4GHz IoT devices frequently disconnected from Wi-Fi, lose connectivity, or become offline/unresponsive", please leave me a message to test the beta firmware.
Thank you very much.
Best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 101
Replies: 3
Voters 1