Ethernet disconnect
Hi. I have a 3 mesh deco x68 system with the hub Ethernet connected to deco 2 which is the connected to deco 3. Everything has been work fine for 6 months and then yesterday I had some connection issues so rebooted my network. Now deco 2 won't work when connected via Ethernet. I have checked cables reset deco 2 but no change. As soon as I connect the Ethernet the light goes red. Works via wireless. I'm stumped. Ideas happily received.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, thank you very much for the feedback.
Can I have the model number of the Ethernet hub?
Is the current network topology like:
ISP modem---main Deco----<Wi-Fi or Ethernet?>----Deco#2----Ethernet Hub----Deco#3
By the way, what is the current firmware version of the Deco X68?
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
Current working setup is - Main Deco X68 V2 connected to NBN Box
Main Deco - Wifi - Second Deco - Wifi - Third Deco.
What was working and what i want working is
Main Deco - Ethernet - Second Deco - Wifi - Third Deco.
but when I plug in the Ethernet to the second deco, it flashes red..
Firmware is 1,2,5 Build 20240805 Rel. 75285 on all decos.
- Copy Link
- Report Inappropriate Content
Hi, thanks for the update.
How about the model number of the Ethernet hub?
Have you tried to run an Ethernet cable directly from the main Deco X68 to the 2nd Deco X68 to see whether the 2nd Deco X68 could stay green?
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
yes.. same result!
I am not sure what you mean by the ethernet hub? I only have the Decos in the network
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 51
Replies: 4
Voters 1
