Business Community > Controllers > oc200 not able to assign vlan1 IP range
< Controllers

oc200 not able to assign vlan1 IP range

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

oc200 not able to assign vlan1 IP range

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
oc200 not able to assign vlan1 IP range
oc200 not able to assign vlan1 IP range
21 hours ago - last edited 15 hours ago
Tags: #Controller #Firmware Update #Adoption
Model: OC200  
Hardware Version: V1
Firmware Version: 1.37.10 Build 20251118 Rel.39419

After upgrading to v6.0.0.34 3 days ago, the controller refuses to assign 15 EAPs and the SG2210P switch to vlan1 192.168.0.0/24. It will only assign the client IPs to 192.168.188.0/24. I really don't know why this is happening. I do not see any other rogue dhcp servers on the same network. so it cannot adopt all the IPs under 192.168.188.xxx.

 

ER605 v2 latest firmware on 192.168.0.1

OC200 latest firmware on 192.168.0.3

SG2210P latest firmware on 192.168.188.72

10 out of 15 EAP225 v3-outdoor on 192.168.188.72

5 out of 15 EAP225 v3-outdoor on 192.168.0.xxx

 

I would like to downgrade the controller, but there is no option do this on omada cloud management. I do not have physical access to the network. Its a 2hr plane ride from my home. I have asked someone onsite to reset the SG2210P switch, but it still shows IP 192.168.188.x. How is this possible unless someone onsite plugged in another dhcp server to the network? I have already rebooted all network hardware multiple time. Can someone please assist on next step tshoot?

  0      
 
  0      
 
#1
Options
3 Reply
Re:oc200 not able to assign vlan1 IP range
16 hours ago - last edited 16 hours ago

  @NoMadMan 

 

The controller doesnt have anything to do with DHCP, that is all coming from your Gateway

Make sure your switch ports and VLAN trunking are in order, bearing in mind the new switch profile changes in v6 - you now assingn VLANs per-port rather than in a profile.

  1  
  1  
#2
Options
Re:oc200 not able to assign vlan1 IP range
15 hours ago

  @GRL 

 

thank you for correcting the mistake on my post. The vlan1 is very basic and nothing special. No other vlans are configured. The SG2210P switch is only used for a couple of EAPs and the controller for power. Again nothing special. I have have asked someone to reset the SG2210P and i assume that it was correctly reset becuase the device name was changed to its MAC address. But it's IP address is still 192.168.188.xxx. At this point i'm ready to reset the ER605.

 

This install is for my 10 room backpacker villa. So nothing special as far as networking requirments. I have a local ISP and starlink as backup.

  0  
  0  
#3
Options
Re:oc200 not able to assign vlan1 IP range
15 hours ago - last edited 15 hours ago

As per @GRL's correction, I will close this thread and post in the gateway fora.

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 51

Replies: 3

Tags

Controller Firmware Update Adoption
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.