Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Query on Easymesh support in birdge mode for Deco device? like x20?

< Deco

Query on Easymesh support in birdge mode for Deco device? like x20?

Query on Easymesh support in birdge mode for Deco device? like x20?

Query on Easymesh support in birdge mode for Deco device? like x20?

2026-01-16 08:59:10 - last edited 2026-02-04 05:58:15

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2026-01-16

Query on Easymesh support in birdge mode for Deco device? like x20?

2026-01-16 08:59:10 - last edited 2026-02-04 05:58:15

Model: Deco X20

Hardware Version:

Firmware Version:

I'm trying to buy a set of mesh.

I have ethernet cable run into my every room so the backhaul is wired.

I have my router (wifi off) from ISP it's in router mode, (NAT, DHCP, etc)

I hope the doco run in bridge mode or AP mode, without routing function like (NAT off DHCP off, DNS relay OFF, pure bridge like a switch, more pure more better.)

can the doco do that?

if in bridge mode the doco can still be accessed via 192.168.1.x????

and config the mesh via the web GUI not the phone APP in bridge mode???

0

0

#1

1 Accepted Solution

2026-01-19 02:49:53 - last edited 2026-02-04 05:58:15

Posts: 18042

Helpful: 2670

Solutions: 3143

Stories: 9

Registered: 2020-04-14

Re:Query on Easymesh support in birdge mode for Deco device? like x20?-Solution

2026-01-19 02:49:53 - last edited 2026-02-04 05:58:15

Hi, you can refer to this link to set Deco into Access Point mode:

How to set up Deco to work in Access Point mode

When Deco is in AP mode, you would still need to use the Deco App to manage the Mesh network, and the web UI can be accessed via http://tplinkdeco.net.

Thank you very much.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Wi-Fi Heatmap ready for all Deco models

Recommended Solution

0

0

#2

1 Reply

2026-01-19 02:49:53 - last edited 2026-02-04 05:58:15

Posts: 18042

Helpful: 2670

Solutions: 3143

Stories: 9

Registered: 2020-04-14

Re:Query on Easymesh support in birdge mode for Deco device? like x20?-Solution

2026-01-19 02:49:53 - last edited 2026-02-04 05:58:15

Hi, you can refer to this link to set Deco into Access Point mode:

How to set up Deco to work in Access Point mode

When Deco is in AP mode, you would still need to use the Deco App to manage the Mesh network, and the web UI can be accessed via http://tplinkdeco.net.

Thank you very much.

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Wi-Fi Heatmap ready for all Deco models

Recommended Solution

0

0

#2