After updating the firmware do not access the firewall.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

After updating the firmware do not access the firewall.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
After updating the firmware do not access the firewall.
After updating the firmware do not access the firewall.
2019-06-18 16:28:52 - last edited 2021-04-19 12:08:33
Model: TL-R480T+  
Hardware Version: V5
Firmware Version:

Hello guysafter updating the firmware of the TL-R480T + I can no longer access it.

tried to perform a manual resetbut it isnot resettingthe LED SYS does not blink.

tried to connect thenotebook directly but all the connections are disabled (tested on all ports).

What can I do in this case after all these tests?

  0      
  0      
#1
Options
3 Reply
Re:After updating the firmware do not access the firewall.
2019-06-19 15:57:48 - last edited 2021-04-19 12:08:33
Just go to serivce-center, nothing you can do.
  1  
  1  
#2
Options
Re:After updating the firmware do not access the firewall.
2019-06-20 01:04:49 - last edited 2021-04-19 12:08:33

Press the reset button for 4-6 seconds. Wait for the router reboot automatically. If still cannot reset he router and SYS LED doesn't blink, maybe the router is damaged.

  1  
  1  
#3
Options
Re:Re:After updating the firmware do not access the firewall.
2019-06-21 14:21:39 - last edited 2021-04-19 12:08:33

That's rightI tried to perform the reset this way but the SYS led doesn't blinkI believe it was damaged.

Obrigado, Tks.

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 1246

Replies: 3

Related Articles