Unable to Adopt an EAP with a changed Username and Password

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Unable to Adopt an EAP with a changed Username and Password

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unable to Adopt an EAP with a changed Username and Password
Unable to Adopt an EAP with a changed Username and Password
2019-11-08 07:06:34 - last edited 2022-09-14 07:06:41
Model: EAP245  
Hardware Version: V1
Firmware Version: 1.4

Hello,

 

I'm taking on a new client with 13 EAP245(US) APs.  Each AP was setup individually without a controller.  Each AP has a different Username and Password.  I've implemented a new OC200 controller on site but when I attempt to "Adopt" the APs, I'm expectedly getting an error that the username and password are incorrect.  I don't see an option to set the U and P within the controller for the APs.  Should I set each AP account back to the default admin/admin before attempting to "adopt"? 

 

Any advice would be greatly appreciated! Thanks!

  2      
  2      
#1
Options
1 Accepted Solution
Re:Unable to Adopt an EAP with a changed Username and Password-Solution
2019-11-08 11:26:52 - last edited 2022-09-14 07:06:41

 

Nuukem wrote

Should I set each AP account back to the default admin/admin before attempting to "adopt"? 

 

To change from standalone mode to managed mode an EAP must be set to factory defaults. Just set the EAPs to factory defaults to be able to adopt them.

 

Own device passwords can be set in Site Settings -> Device Account.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
Recommended Solution
  2  
  2  
#2
Options
2 Reply
Re:Unable to Adopt an EAP with a changed Username and Password-Solution
2019-11-08 11:26:52 - last edited 2022-09-14 07:06:41

 

Nuukem wrote

Should I set each AP account back to the default admin/admin before attempting to "adopt"? 

 

To change from standalone mode to managed mode an EAP must be set to factory defaults. Just set the EAPs to factory defaults to be able to adopt them.

 

Own device passwords can be set in Site Settings -> Device Account.

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
Recommended Solution
  2  
  2  
#2
Options
Re:Unable to Adopt an EAP with a changed Username and Password
2019-11-08 22:58:45

@R1D2 Thank you!

  0  
  0  
#3
Options

Information

Helpful: 2

Views: 10618

Replies: 2

Related Articles