Novice trying to configure CPE210s as AP and client

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Novice trying to configure CPE210s as AP and client

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Novice trying to configure CPE210s as AP and client
Novice trying to configure CPE210s as AP and client
2020-09-20 19:24:43
Model: CPE210  
Hardware Version:
Firmware Version:

I'm trying to set up two CPE210s as an AP and client to get wifi to a remote garage (outdoor distance between AP and client is about 100 feet).

 

Router------>AP  -    -    -    Client------>wifi router   -    -    -    (smart garage door opener, etc.)

 

I configured and installed both the AP and client; they're talking, and there's internet from my router to the AP.  But I can't connect to the internet from the client.  I tried connecting a wifi router to the client; no internet.  I then tried to troubleshoot by connecting a laptop to the client via ethernet.  IPv4 connectivity says "No network access," and IPv6 connectivity says "No Internet access."

 

Seems to be a configuration issue with the client?  What have I done wrong here?  TIA.

  0      
  0      
#1
Options
3 Reply
Re:Novice trying to configure CPE210s as AP and client
2020-09-22 06:31:19

Dear @ams2100,

 

I then tried to troubleshoot by connecting a laptop to the client via ethernet. IPv4 connectivity says "No network access,"

 

What's the LED Status on the CPE210_Client? Does the laptop obtain IP info including IPv4 Default Gateway and DNS servers after connecting to the CPE210_Client? 

 

If the Wireless signal LEDs are OFF on the CPE210_Client, it's suggested to reconfigure the CPE210 as Client mode, ensure you select the correct SSID and input the correct password to connect to CPE210_AP. The following instructions are for your reference.

 

How to Configure the Client Mode on the Pharos device?

How can I set up the AP + Client topology successfully?

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:Novice trying to configure CPE210s as AP and client
2020-09-23 01:08:18

@Fae 

 

Thanks for your reply!

 

The power and LAN LEDs are one; the other four LEDs cycle on and off together (all on long, then all off short).  
 

I don't think the laptop obtained the IP info, but I won't be able to confirm this for several days (the CPEs are at my cabin, and I won't be there again until Friday). 
 

Any additional advice appreciated!

  0  
  0  
#3
Options
Re:Novice trying to configure CPE210s as AP and client
2020-09-23 06:25:50

Dear @ams2100,

 

Please check for this post for further advice. Do write back to us if any further assistance needed. Thank you.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 859

Replies: 3

Related Articles