Mesh
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
I just purchased an EAP265 to add to my network.
Currently it consists of an
OC200 Controller
EAP225
and a new EAP265 HD
I notice when going into the Controler and clicking on the EAP's >Config that the EAP265 HD does not have an option for Mesh. Is this so? I was under the impression that it did sinse it is the newer model.
Thank you
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @Super7,
I notice when going into the Controler and clicking on the EAP's >Config that the EAP265 HD does not have an option for Mesh. Is this so?
May I know the current firmware version of your EAP265 HD？
Kind note that the first firmware EAP265HD_V1_Build 20200424 doesn't support the mesh feature, but it supports in the later firmware.
You may check the current firmware and upgrade it accordingly if it's not up to date.
https://www.tp-link.com/support/download/eap265-hd/#Firmware
- Copy Link
- Report Inappropriate Content
@Fae
Hi,
This is what it currently has:
Model:
EAP265 HD(US) v1.0
Firmware Version:
1.0.0 Build 20200424 Rel. 38630
When I go to the link you suggested,
https://www.tp-link.com/support/download/eap265-hd/#Firmware
There is only 1 firmware there. When you say, "but it supports in the later firmware", I don't see how I can update it.
Thank you
- Copy Link
- Report Inappropriate Content
Dear @Super7,
When I go to the link you suggested,
https://www.tp-link.com/support/download/eap265-hd/#Firmware
There is only 1 firmware there. When you say, "but it supports in the later firmware", I don't see how I can update it.
Thank you for the feedback, it seems that the firmware is not uploaded on the website of your region, I'll remind the web administrator.
For your case, you could refer to the link below for the firmware EAP265HD(US)_V1.1.0 Build 20200619.
https://www.tp-link.com/ca/support/download/eap265-hd/#Firmware
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 800
Replies: 3
Voters 0
No one has voted for it yet.