I noticed the delayed much time in the actual activity for example speed of bandwidth used by one client in AP OC200 controller. I believe around 5 minutes or less.

I have a bandwidth monitoring from my router for all client device I can see the real-time status of bandwidth utilization where I noticed the actual spike for example of one client I seen from my router takes around 4-5 minutes before it actually shows on the same client from Omada OC200 controller system. Please advise if there's a way to make it at least few seconds delay only since if I'm monitoring the bandwidth or traffic I can't see or monitor the real-time utilization of each devices in the network. I noticed this after I upgrade to 4.2.8 for oc200 and update for eap225 outdoor  5.0.0 Build 20200918 Rel. 58628. looking forward.