Business Community > All Threads > octet counter
< All Threads

octet counter

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

octet counter

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
octet counter
octet counter
2021-06-27 09:24:06 - last edited 2021-06-29 03:31:12
Model: SG2008P  
Hardware Version: V1
Firmware Version: 1.0.1

Traffic monitor reports only number of packets,

octet counter is always zero.

snmpwalk say also net.if.in/net.if.out is zero.

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:octet counter-Solution
2021-06-28 08:15:11 - last edited 2021-06-29 03:31:12

Dear @kdash,

 

kdash wrote

Traffic monitor reports only number of packets,

octet counter is always zero.

snmpwalk say also net.if.in/net.if.out is zero.

 

Here is the beta firmware to fix the traffic statistics issue, which can be found in this post.

 

https://static.tp-link.com/beta/2021/202106/20210604/TL-SG2008Pv1_en_1.0.1_[20210602-rel72106(Beta)]_up.rar

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:octet counter-Solution
2021-06-28 08:15:11 - last edited 2021-06-29 03:31:12

Dear @kdash,

 

kdash wrote

Traffic monitor reports only number of packets,

octet counter is always zero.

snmpwalk say also net.if.in/net.if.out is zero.

 

Here is the beta firmware to fix the traffic statistics issue, which can be found in this post.

 

https://static.tp-link.com/beta/2021/202106/20210604/TL-SG2008Pv1_en_1.0.1_[20210602-rel72106(Beta)]_up.rar

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
Re:octet counter
2021-06-28 13:12:18

@Fae 

Fae wrote

Dear @kdash,

 

kdash wrote

Traffic monitor reports only number of packets,

octet counter is always zero.

snmpwalk say also net.if.in/net.if.out is zero.

 

Here is the beta firmware to fix the traffic statistics issue, which can be found in this post.

 

https://static.tp-link.com/beta/2021/202106/20210604/TL-SG2008Pv1_en_1.0.1_[20210602-rel72106(Beta)]_up.rar

I found snmp counter net.if.in/net.if.out counts up normally.

Thank you fae.

 

kdash.

 

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 618

Replies: 2

Related Articles
BUG - Checking for counter rollovers
593 0
ACL Counter not Incrementing despite packets getting matched
722 0
Cannot update firmware on TL-SG2008P v1.0
1214 0
Disabling just the POE on a port so I can plug a non poe device into my switch.
1795 0
How to configure a Trunk Port
939 1
Replace Main Network Switch
378 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.