TL-R605 Adopt Failed
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I had some issues a few weeks ago(4 or so), when the Dashboard showed that the R605 "Adopt Failed". I tried to readopt, but it asked for a password that i either did not remember or i just don't know. I tried dozens of passwords i normally use, but neither of them worked.
I didn't want to reset the router, because i didn't have the time to set it all up the way it was.
Then, we had a power outage in the neighborhood. When i logged in the dashboard afterwards, i noticed that all devices were adopted again, including the R605.
That was terrific news. It showed a firmware update icon, but i didn't want to update yet. Then i logged in this morning and saw the "Adopt Failed'' notice again. Readopt doesn't work, because i have to use the username and password again.
Why does this happen? I took a look at the download page for firmware, but i already use the latest firmware. Why did the dashboard show a "new firmware" icon?
Anyone else with similar issues?
The Username and Password is on the "Setting--Site--Device Account", you can try to use this username and password to adopt the ER605.
Also you can try to power off ER605 and your controller, then power on back to check if the ER605 will adopt automatically.
As for the firmware update note, the current firmware(1.0.1) you have is the latest one, another new firmware (1.1.0) will come out soon and not release on the website yet, so there is a little notification on the controller but fail to upgrade.
All make sure all the devices are in the same subnet as 192.168.0.x.
