Model: TL-SG2428P v1.0 firmware upgrade to 1.1.2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Model: TL-SG2428P v1.0 firmware upgrade to 1.1.2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Model: TL-SG2428P v1.0 firmware upgrade to 1.1.2
Model: TL-SG2428P v1.0 firmware upgrade to 1.1.2
2021-10-18 21:40:02 - last edited 2021-10-19 05:53:56
Model: TL-SG2428P  
Hardware Version:
Firmware Version:

Anyone know where the release notes are for this firmware, I like to know whats changed - I'm being prompted that an update to 1.1.2 is available.

  0      
  0      
#1
Options
1 Accepted Solution
Re: Model: TL-SG2428P v1.0 firmware upgrade to 1.1.2-Solution
2021-10-19 05:52:49 - last edited 2021-10-19 05:53:56

Dear @biomed32uk,

 

biomed32uk wrote

Anyone know where the release notes are for this firmware, I like to know whats changed - I'm being prompted that an update to 1.1.2 is available.

 

Enhancement/Bug Fixed:
1. Fix the bug that Tx/Rx statistics of port is not accurate.
2. Fix the bug that IP address of L3 interface is not correct when the interface is down/up.
3. Fix the bug that bootutil can not be accessed via micro-USB port.


Notes:
1. For TL-SG2428P(UN) 1.0
2. This firmware is fully compatible with Omada Controller v4.3 or above.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re: Model: TL-SG2428P v1.0 firmware upgrade to 1.1.2-Solution
2021-10-19 05:52:49 - last edited 2021-10-19 05:53:56

Dear @biomed32uk,

 

biomed32uk wrote

Anyone know where the release notes are for this firmware, I like to know whats changed - I'm being prompted that an update to 1.1.2 is available.

 

Enhancement/Bug Fixed:
1. Fix the bug that Tx/Rx statistics of port is not accurate.
2. Fix the bug that IP address of L3 interface is not correct when the interface is down/up.
3. Fix the bug that bootutil can not be accessed via micro-USB port.


Notes:
1. For TL-SG2428P(UN) 1.0
2. This firmware is fully compatible with Omada Controller v4.3 or above.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 976

Replies: 1

Related Articles