Adoption/Provisioning-Loop TL-SG2428P v1.0
Hallo,
als Neuling hier bitte ich direkt um Entschuldigung, falls ich zum Thema passende Threads bisher nicht gefunden habe.
Ich habe bei mir nun seit fast vier Jahren einen TL-SG2428P im Einsatz. Seit dem letzten Firmware-Update und dem folgenden Reboot hängt der Switch allerdings in einer Adoptions/Provisionierungs-Schleife fest. In der Übersicht meines OC-200 wechselt der Status seitdem ununterbrochen von Adopt -> Provosioning ->. Adopt -> Provisioning usw.
Ich habe den Switch auf dem Controller bereits entfernt, dann einen Reset durchgeführt und die Adoption neu gestartet, leider kein Erfolg, gleiches Ergebnis. Gibt es hierzu eine Lösung? Nach dem Reset ist der Switch zumindest über die eigene Web-Oberfläche ansprechbar.
Ich freue mich über jegliche Anregungen.
Danke im Voraus.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hallo @Clive_A,
thanks again for your support.
After a few tests, the decisive hint came from one of your German support colleagues. He recommended that I downgrade the switch firmware.
Instead, I first updated the OC-200 firmware to the latest version. The switch could then be integrated again and the network was up and running again.
Many thanks for your efforts and support.
Kind regards
- Copy Link
- Report Inappropriate Content
Hi @Marc-214
Thanks for posting in our business forum.
Where did you get TL-SG2428P V1 1.1.12?
I don't see it available on the global site.
Also, the whole Internet cannot find 1.1.12.
- Copy Link
- Report Inappropriate Content
Hi @Clive_A ,
Thanks for your quick reply.
The firmware upgrade was offered to me on the interface of my OC-200. Assuming that only correct and authorised upgrades are offered to me on this interface, I confirmed the upgrade. Since then I have been experiencing the problem described.
- Copy Link
- Report Inappropriate Content
Hi @Marc-214
Thanks for posting in our business forum.
Marc-214 wrote
Hi @Clive_A ,
Thanks for your quick reply.
The firmware upgrade was offered to me on the interface of my OC-200. Assuming that only correct and authorised upgrades are offered to me on this interface, I confirmed the upgrade. Since then I have been experiencing the problem described.
What's the controller version?
Please take a look at the controller page where recently an official version was removed.
If you are on the pulled off version, consider downgrading the controller to avoid an issue on the troubled version.
Even after the reset, you try to adopt it back to the controller, the issue persists?
Can you show a diagram of your network with IP marked out?
- Copy Link
- Report Inappropriate Content
Hallo @Clive_A,
thanks again for your support.
After a few tests, the decisive hint came from one of your German support colleagues. He recommended that I downgrade the switch firmware.
Instead, I first updated the OC-200 firmware to the latest version. The switch could then be integrated again and the network was up and running again.
Many thanks for your efforts and support.
Kind regards
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 84
Replies: 4
Voters 0
No one has voted for it yet.