OC200 Firmware 5.3.1
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @Sc0th,
Sc0th wrote
Am I stuck with an overpriced doorstop until the update is release for the OC200 (could be months?!) or is there an alternative solution to migrate?
Sorry for any trouble caused. The OC200 Controller 5.3 has been released today, please take your time to upgrade it!
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Sc0th suspected that may be the case, thanks for the confirm, I shall wait in hopeful anticipation :)
- Copy Link
- Report Inappropriate Content
Me too. My Docker based controller is already at 5.3.1 but my OC200 lags behind at 5.1.7. I have no idea why the lengthy delay in releasing it on known and well controlled hardware.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
from Fae ( from another thread on this forum)
They found a major bug in 5.3.1 for OC200/300
They need to fix this first. The bug didn't exist on the software 5.3.1
- Copy Link
- Report Inappropriate Content
Dear @Sc0th,
Sc0th wrote
Am I stuck with an overpriced doorstop until the update is release for the OC200 (could be months?!) or is there an alternative solution to migrate?
Sorry for any trouble caused. The OC200 Controller 5.3 has been released today, please take your time to upgrade it!
- Copy Link
- Report Inappropriate Content
@Fae Thank you! However..... do you think there will be any issues going from software controller 5.3.1 -> OC200 5.3.2?
It does specifically say 'same version' on the migration page, to the best of my knowledge there is no 5.3.2 software controller version.
- Copy Link
- Report Inappropriate Content
Dear @Sc0th,
Sc0th wrote
@Fae Thank you! However..... do you think there will be any issues going from software controller 5.3.1 -> OC200 5.3.2?
It does specifically say 'same version' on the migration page, to the best of my knowledge there is no 5.3.2 software controller version.
No worries. It's okay to migrate from software controller 5.3.1 to OC200 5.3.2, they are both version 5.3.
- Copy Link
- Report Inappropriate Content
@Fae Great thanks for the confirm, I shall make it so!
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1333
Replies: 10
Voters 0
No one has voted for it yet.