Automatic routing table refresh
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Good morning everyone!
I have a doubt and it's because i can't find the information about this topic in TP-Link devices.
I have my default gateway which next hop is my router1 192.168.10.3, as always.
0.0.0.0/0 192.168.10.3 1
But I was configuring a network which switchs routes, after testing by ping (it's a feature in my Mikrotik routers, so it switches the routes automatically based on ping and distance in this routes).
I need to route as backup for default gateway my router2 192.168.10.7, but i'm not sure that this T1600 is capable of testing routes, and after all I have no clue about the state of the routes, as in my Mikrotik devices... So the question is: is it enough to configure this route to my router2 with a distance of 2 (router1 with distance 1) and i'm sure that if my router1 is unreacheable, my switch will forward packets to my router2? Or this is not a feature for this device?
Thank you!
