Can't rename ports in ER7206 Router using Omada OC200 Controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2023-05-03 02:26:30 - last edited 2023-05-03 23:09:38

Posts: 41

Helpful: 19

Solutions: 1

Stories: 0

Registered: 2020-09-14

Can't rename ports in ER7206 Router using Omada OC200 Controller

2023-05-03 02:26:30 - last edited 2023-05-03 23:09:38

Model: OC200

Hardware Version: V2

Firmware Version: 5.9.32

Hi, I can rename my ports in my TL-SG2210P v5.0 switches okay, but I can't rename the ports in the ER7206 router using the Omada OC200 controller. All my firmware was up to date, so I tried some beta firmware and that's doing the same. See the screen snip. SFP WAN is my main internet, and the WAN port is my failover internet backup. The remainder (highlighted below) are all used as LAN ports only. Thanks in advance.

Paul

1 Accepted Solution

LV5

2023-05-03 05:13:13 - last edited 2023-05-03 23:09:38

Posts: 2258

Helpful: 807

Solutions: 289

Stories: 0

Registered: 2018-08-17

Re:Can't rename ports in ER7206 Router using Omada OC200 Controller-Solution

2023-05-03 05:13:13 - last edited 2023-05-03 23:09:38

the simple answer is, you can't. if you put it on Requests & Suggestions, I'll vote for it :-)

Helpful: 0

Replies: 2