Best set-up for Ring PoE cameras with TL-SG1210MPE
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello!
I've been using the router for about a week now and my Ring cameras keep dropping out. I bought this specifically because of the auto recovery feature. However, when I try to "Enable" the "Status" under the "Port Config" section of the PoE Auto Recovery screen, it tells me I need to "Enter a valid IP address":
Here's the kicker though... I've been through every page/screen in the router, and nowhere does it tell me what the IP addresses are for each port. Anyone know how to do that?
Also, here are screenshots of my current settings. I figured the more basic the better?
Other info:
- I have the internet hooked up to Port 9.
- I have one disabled cam hooked up to Port 7 (haven't gone out to scan the QR code to set it back up yet).
- Ports 8 and 10 are empty.
Thanks in advance!
As I seen, it should be the IP address of each POE cam which is connecting to the switch ports now. It has said that on your pic:
And to make sure the IP address does not change, better to set DHCP reservation to each cam.
