ACL Network GUI Bug

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ACL Network GUI Bug

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
ACL Network GUI Bug
ACL Network GUI Bug
2024-01-20 23:13:44
Tags: #ACL
Model: OC300  
Hardware Version: V1
Firmware Version: 1.19.3 Build 20230906 Rel.38429

Hi all,

I noticed a bug in GUI of ACL feature in Omada SDN 5.12.9 .

When an ACL is getting set and the source is of type Network, then the user intuitively click on the network name to set the source network.

The bug happens when the destination type gets selected. I tried only to select Network as destination type, so I didn't fully test all the combinations, but basically at the click event, the source network name list gets reset to empty.

 

Probably there is a typo in variable that host the names of the source networks or the mechanism has not been implemented correctly or at all. Up to you! :)

 

This is minor bug, ofc! ;)

 

Thank you,

Fra

  0      
  0      
#1
Options
1 Reply
Re:ACL Network GUI Bug
2024-01-22 07:05:54

Hi @nicolati,

 

Thanks for reporting this issue to our Business Community!

 

I just tested the interaction of ACL-related settings as you mentioned, but didn't find the same issue, it's working properly, and I'm using the controller v5.13.

Could you clarify which ACL you test? Gateway ACL? Switch ACL? EAP ACL?

 

You may also upgrade the controller to v5.13 for testing.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 419

Replies: 1

Tags

Related Articles