Hello,

I'm having an issue with Static Routes between two ER7206 routers.  I am trying to set-up a network that "simulates" the internet -- but really, I just want to have traffic from one subnet on one ER7206 travel to a another subnet on a separate ER7206 router.

I have the two ER7206 routers connected via their WAN2 ports.  Both WAN2 ports are set for Static IPs with the configuration listed below, with Static routes configured for the subnet on the other router.  From a PC on either subnet, I can ping the local router IP, and the WAN IP of both routers.  However I cannot ping or telnet any PCs on the opposite subnet.  tracert fails after two hops -- the two hops that succeed are the local LAN IP of the router, and the local WAN IP of the router.  It does not get to the remote WAN port of the other router.  I even tried setting default gateways on the two WAN2 ports, but that doesn't seem to help either.

Is static routing on the ER7206 broken?  Or am I configuring something wrong?  I thought this was going to very simple but I have been struggling to get it working for the last couple days.  A somewhat detailed config list is below.  Thanks in advance!

Router 1 Config:

• WAN2:
  • IP Address: 192.168.100.4/24
  • Default Gateway: 192.168.100.2

• LAN:
  • IP Address: 192.168.0.1/24
  • DHCP Enabled

• Static Route
  • Destination IP: 193.168.2.0/24
  • Next Hop:  192.168.100.2
  • Interface: WAN2
  • Metric: 0
  • Status:  Enabled

Router 2 Config:

• WAN2:
  • IP Address: 192.168.100.2/24
  • Default Gateway: 192.168.100.4

• LAN:
  • IP Address: 193.168.2.1/24
  • DHCP Enabled

• Static Route
  • Destination IP: 192.168.0.0/24
  • Next Hop:  192.168.100.4
  • Interface: WAN2
  • Metric: 0