Wireguard IPv6 - can't connect from "outside"
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dears,
due to the fact that my ISP can't provide me a public IPv4 (so DynDNS won't work anymore) I want to connect my iPhone to my local network using wireguard.
From my local network the iPhone can connect without any problems via wireguard to the router so public keys, general settings, etc. should be fine. But from outside my local network I only receive "Handshake did not complete after 5 seconds, retrying..."
Is there anything additional to configure to access the router from outside? I even tried to allow any IPv6 connection in ACL but I still can't connect.
[Interface]
PrivateKey = xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Address = 192.168.69.11/24 -> my local network has 192.168.1.1/24 so no collision
DNS = 1.1.1.1
[Peer]
PublicKey = xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
AllowedIPs = 0.0.0.0/0, ::/0
Endpoint = [my WAN IPv6 adress 2a00:...]:51820
Thanks a lot in advance and greetings from Hamburg
mojo
