Just ran into an issue that cost me a few hours of troubleshooting, figured I'd document it here. Setup: Deco BE85 (Router mode) Firmware 1.2.1 WireGuard server running on a device behind the Deco The

I am in the UK and we have FTTP (Fibre to the Premises) with Zen Internet. We also have digital voice - i.e. a landline. I recently replaced my ISP-provided Fritzbox with a Deco X55 (hardware version

I've finally had it with Home Shield First it blocked access to my network devices, printers, Nas etc.... Adding exceptions took care of that.... But it took a while to figure out out it was this soft

I installed 3 Deco X55 devices in access point mode, connected via cable. When turned on, everything works normally. However, after a while of use, the network starts to become unstable. In some situa

Hi, First time post. I'm trying to set up pair of Deco X50 on plusnet full fibre to replace an existing mesh. I'm trying to not change a lot of static ips. I installed the first x50 and connected it t

I use adguard dns as a home ad blocking dns. I tried to use DoH custom address from AdGuard on my Deco under DoH & DoT section and it says the address is invalid format. I wonder if your DoH only supp