my deco does not show up my windows 11 computer. i distribute a fixed DHCP IP to stable the connection between my windows and my Quest2. but my deco does not show up my windows computer on the list of

The problem is that random ESP devices are causing up to 150 MQTT disconnects per 24 hours. Configuration: 5x X50 Decos and 3x TP-LINK managed LAN switches, the DECO backhaul is via a Gbit LAN. No Rx

I recently started using wifi access control to block unknown device from connecting the wifi. I set the wifi access control to allow list mode and added my iPad MAC address to the allow list. However

I have a Deco network consisting of three PX50 and one BE25. I got a message to update firmware. When I initiated Deco update using the iOS app, I get the error message that no Decos are found. On the

Where can I see the connection type of a deco unit in the app? I connected one of my units to a wall socket, but in the app, that unit shows a weak WiFi signal. when I connect it directly to the route

Dear TP-Link Support, @Sunshine @David-TP I am using the TP-Link Archer NX200 router (Hardware Version: v1.0, Firmware Version: 1.6.0 3.0.0 v60a2.0 Build 250529 Rel.55411n). I have configured the rout