@jra11500 I can confirm a similar behaviour For me, all devices are properly highlighted on the correct VLAN the first time i select that vlan in the list. After that, if i reselect the same VLANs...

@jra11500 Switch allow rules will just let the traffic sent by the client hit the gateway or direct L2 frame-forwarding if on the same vlan (gateway not needed, if the switch MAC table has the...

@SCMAF Are they in different locations? if so, establish a VPN between them (at least one of them needs a static IP, or you have DDNS setup), include the Caera subnet in the tunnel If they are in the...

@n00r Looks like you have a vlan trunking issue. The EAP port must have the non-management vlans as tagged members, and they must also be tagged, and exist on the gateway uplink port as well The EAP...

@jra11500 Switch ACLs work without needing an interface on any particular VLAN, since all SG class and better switches are L3 capable they inspect packet headers of anything traversing the switch,...

650v1 with the stable 1.1.3 works fine with controller 6.1 and 6.0, you arent missing out on too much. There is no reason to delay controller updates to jsut wait for EAP firmware.