@SebastianH Just redo your gateway ACLs as switch ACLs and you should be fine. It's all abstracted by the controller, so as long as your switches' port profiles are done correctly, the controller...

@SebastianH What router and firmware version are you trying to make ACLs work on...there are very limited options (7206 may) that can and a lot that don't work at all (605, 7212 etc). I'll be honest,...

@RobinGL Are you saying the AP is on the WAN side of the router (in front), if so then that's pretty normal behaviour...though I'm curious how the AP and wireless clients are assigned addresses in...

@OrangeStreet Ok, you said you cannot run a wire to the remote unmanaged switch location. So it sounds like at least 1 of the 5 APs hanging off the switch is meshed back to a wired AP hanging off one...

@snowch No, it's static weighting, dynamic would require a lot more than what is available on these devices today. Unless one carrier is consistently say 2x better 24/7 than the other, I'd just set...

It's worse, there's a pretty good chance your CLI gets overwritten anytime you make a minor change elsewhere on the switch. In the meantime, couldn't you just add a second ethernet port on your NAS...