@Andi_ If you check your Fritzbox, you should see the DHCP reservations assigned to the APs AND your wifi clients. Not sure why it would hand out IP's on separate subnets by default...but as above...

@rakrouki Cable is suspect: - switch port is only 10/100 - too long - broken wire in a pair - poor crimp - inferior connector/plastic fin damaged between pins

if you need finer granularity, why not do a test ping to validate users? I don't think the Omada user list is intended for real-time presence info ;)

@Fozzie Bear One last thought on the PI...if something goes wrong ie glitchy USB power supply, cheap SDRAM card and the filesystem gets corrupted, you are hard down, and without a backup of the...

@Fozzie Bear So on the static IP, by which I assume you mean 'Reserved IP'. This can and will work on any controller solution/arch, but often you have to power cycle at least the AP in order for the...

You would likely need to factory default all devices and readopt them after connecting them to a v3.x controller. I am using oc200's and Docker over Linux (for my PI and NAS based controllers). My...