@SteveMann So you were using a version below 5.13 then on both software and oc200?

@dunxd Thanks for the feedback...hoping they iron out these bugs before dropping the full release.

@SteveMann Everything. Just like if the universe had just been born and you found yourself standing in the black void holding an OC200. But wait, there's light... Now, if you have backups from older...

I'm with kilovar above, 1G RAM is just not enough for 5.13 controllers. Try installing a 5.8 or older controller. I run mine in containers, but to put things in perspective, you need at least 1.2G...

@SteveMann Currently, with the latest versions of the Controllers you cannot migrate between hardware and software (there is another thread on this). So if you are running 5.13 on your Pi, you will...

@BengGaBoy As far as I know, the latest EAP650-wall firmware is not currently mesh capable. There might be hope though, as the EAP615-wall has some beta code out that does now support meshing.