@Sascha75 The EAP650-wall does not support mesh at this time. The EAP615-wall with the latest firmware does.

@mickeyr0124 Yes, you can configure multiple SSIDs per AP, each tagged with a unique VLAN. Yes, those AP support meshing as long as you have an Omada controller as part of your design. Yes, you can...

Ha! I'd just ignored the "red"-acted area. Hats off to you Clive :) Almost certainly the poor performance is due to poor mesh topology. Can you provide the 'Topology' generated by the Controller and...

@Morris211 I am not sure how Clive determined you were using the wireless mesh capability, however that could impact the backhaul performance to your internet (and cause a lot of those packet...

@Michiel_H @Hank21 Hank, tell me this isn't so? If it is, do I need to submit a feature request to actually make it possible again to migrate sites between h/w and s/w controllers?

@AceHome Leave the channel on Auto, but set the Bandwidth to 20Mhz, reboot AP. Depending on how much RF noise in your neighbourhood, you should hit 50-80Mbps if you are that close. 90Mpbs is pretty...