Just saw an 'upgrade' notice in the controller for my v1 EAP615-wall which states it now supports MESH! Wondered if any other wall versions out there have similar notes in their latest firmware?...

@Nvb2 In my region an SG105PP is about 3X the cost of a 2.5G capable POE injector. This would allow you to run everything off the 3210-nonPOE and skip the SG105 layer. The downside of POE injector...

@Nvb2 1. LAG (LACP) is only supported on TPlink switches at this time. Yes, you would need to bond 2x1G to continue the higher BW connection downstream 2. My suggested architecture would 'limit' and...

@Benjamin92 Did you get your timerange logic correct? Did you reset the AP after you created and applied the Schedule profile?

@Nvb2 Actually you have the 3210XHP-M2 ie the POE variant. I am suggesting the fanless non-POE version which you can then use with the SG105's you show above, or other fanless manageable POE switches...

@JamesLu Even in standalone mode, routers are able to be adopted by controllers. Given this is a broadcast packet, and likely only broadcast on the admin domain of 192.168.0.1, it's only visible...