@Benjamin92 Did you get your timerange logic correct? Did you reset the AP after you created and applied the Schedule profile?

@Nvb2 Actually you have the 3210XHP-M2 ie the POE variant. I am suggesting the fanless non-POE version which you can then use with the SG105's you show above, or other fanless manageable POE switches...

@JamesLu Even in standalone mode, routers are able to be adopted by controllers. Given this is a broadcast packet, and likely only broadcast on the admin domain of 192.168.0.1, it's only visible...

@snowch These are typically related to poor signal conditions or high noise/interference in the local area. Short of trying a different channel or adding more APs, not sure what you can do here.

@ProSumerTester I think you are mis-interpreting...what you are showing are your Conroller SSID definitions, not the config or capability of the AP. The controller could apply a profile with 6Ghz to...

@Jorrig Almost certainly related to your power source. Can you confirm that you have a 1.5A (14W) or better supply? 1.0A could cause brownout issues. Keep in mind that Watts = Amps x Volts and you...