I just noticed that the other devices in that network shows a “Controller Connection IP” setting set to the WAN IP address of that network, not the WAN IP address of the remote controller. Is that...

@Clive_A Thanks for your response. I SSH into one of the VMs of the network with the failed gateway. I performed the following curl command to check for connectivity to the controller (I checked to...

A couple of days ago 07/17/2025, my ER605 V1 has suddenly gotten stuck at a provisioning/adopting loop. It fails and I get a notification that the gateway has disconnected. I tried force provisioning...

d0ugmac1 wrote @t3knoid There is something missing from this story.. If you unplug your working, managed 235wall and plug the freshly defaulted 615wall to that same cable does it: 1. Show as a Client...

@d0ugmac1 The only reason I mentioned it is because I am unable to configure out of the box. So basically I am grasping at straws at this point. My network is a typical home network (e.g....

@d0ugmac1 I "defaulted" as suggested in that video...several times. I can see that the box is reset to default each time. Quite frankly, I didn't see a difference with using the hard reset or soft...