MR.SLV5Online
Following: 6Followers: 18
Forums/ Routers
a week ago
Re:Upgraded ER707-M2 to Firmware 1.2.3 and Wireguard VPN went BOOM!
@Daggett I looked through your setup and have modified it the way I think it should be. ~Wiregaurd VPN Omada Server Config MTU: 1420 Listen Port: 51820 Local IP Address: 192.168.192.1 Private Key:...
0HELPFULS
Forums/ Routers
a week ago
Re:Adoption Loop when ACL are enabled on gateway ER605 V2_2.2.6 Build 20240718 Rel.82712
@Berg-UA ok, if it is as you have shown me then everything works as it should, if you have deleted the acl rules on the router switch and eap you also have nothing blocking. so then you have to look...
0HELPFULS
Forums/ Routers
a week ago
Re:Adoption Loop when ACL are enabled on gateway ER605 V2_2.2.6 Build 20240718 Rel.82712
@Berg-UA I would like to see how you have configured your camera network, you haven't shown me any screenshots of how it is configured.
0HELPFULS
Forums/ Routers
a week ago
Re:Adoption Loop when ACL are enabled on gateway ER605 V2_2.2.6 Build 20240718 Rel.82712
@Berg-UA there is no picture of the camera network
0HELPFULS
Forums/ Routers
a week ago
Re:Er707-m2 vlan trunking to 3rd party FS switch
@AussieBob It is connected to the router, there is only one switch in the network.
1HELPFULS
Forums/ Routers
a week ago
Re:Er707-m2 vlan trunking to 3rd party FS switch
@AussieBob I have a FS switch connected to an ER707-M2, it's actually quite simple. Make sure that VLAN 1 is untagged on the trunk port to router and on the ports you have connected the access point...
1HELPFULS
191011...