@Sans36 Hi, the factory reset of Deco only needs to hold the reset pinhole for 1s. If the factory reset didn't make any difference, it is also suggested to refer to this link to run a firmware...

@yoss_100 Hi, did you just purchase Deco X50-POE? How about the model number of your EasyMesh router? Deco X50-POE doesn't support EasyMesh. An EasyMesh-compatible range extender would be much...

@BengtN Hi, welcome to the community. Is your modem router Deco X50-DSL_1.0.4 Build 20240103 Rel. 64294? Do you have any other satellite Deco units? I don't think it is due to the Firewall settings....

@YoursAchie Hi, welcome to the community. You can test to install the 1.3.1 firmware here: Deco X50/X55_V1.3_1.3.1 Introduced Channel Selection, WiFi Access Control and WireGuard VPN Best regards.

@Porkshanks Hi, actually, when you registered the forum, this email will be registered with TP-Link Cloud as well. So only one password can be set. Later, you can use these credentials for the Deco...

@fenn Hi, thank you very much for the feedback. I'd like to follow up on your case via email and forward it to the senior engineer for further assistance. Can you update the email with some...