Since this relies on EAP firmware, does it require ALL EAPs to support it? I assume so. It would be useful to know which EAP models will get the feature and which will not.

My understanding is that the Smart DHCP is intended to kick in if the powerline device detects that there is no DHCP server on the network. I guess this was done to allow clients to access the config...

It's very disappointing that the TP-Link folk responding to a message to this thread, over 200 messages long, don't consider that context and treat new messages as if they were brand new support...

I was subsequently informed by TP-Link support that the ER605 also uses 192.168.0.1 as a default address. It appears that I was reaching this instead of the switch address due to the conflict and...

@Virgo it was already gone. I noticed that after resetting, the switch picked up a different address by DHCP which was not showing the error message and I was able to add it. However it was also...

My switch lost connection to the Omada Controller, so I used the reset button to factory reset it. Now when I access it via the factory default IP (https://192.168.0.1) the page says that the switch...