Dear @switch_Lines, I have cpe 510, the signal is ok, and connections is ok, and the IP’s is ok, but when I ping the second cpe 510, every 5 min I have 4 request timeouts. The current firmware is a...

Dear @ClintonBrits, We are still unable to get 2 antennas to connect and we recently looked at altitude survey between the 2 locations and we noticed the one is +-30m higher and seperated by 4km. Do...

Dear @JACKFOK, Once again thank you for your help. If I refer to this FAQ, and I have the same three nos. of VLAN and L3 interface setting on my T1600G switch. What about the IPv4 static route...

Dear @JACKFOK , Just asking if I decide the network will not need to access Internet, can the T1600 G switch will do the inter-vlan routing by itself only without the help of router ? Thanks. I...

Dear @AndreMartins, Is there any chance of managing T2600G with Omada SDN ? Is there a plan to include it ? I'm afraid not. This has been discussed in this post.

Dear @PManley, I have excluded ports 3-12, 49 from VLAN 1. And I've set up a separate VLAN 1403 for ports 3-12, 49. Port 49 is a TAGGED port. The others are UNTAGGED. And I've configured ports 3-12,...