@0x0mehrab DoH is implemented in FW v1.13.2. So you'd better stay on that version until a stable version is released. Here's the FW v1.13.7 which is a beta FW release and it should be suitable for...

@be800 This speed cap is usually caused by the ethernet cable that you're using. Change the cable with another òne of a good quality and test if the speed cap has gone.

@RandyAndy Session timeout is hardcoded into the device FW. It can't be changed by the device WebGUI. I am using an easysmart switches on which the timeout is 10 minutes.

@tplnkuser101 FW v1.13.5 was probably meant to be a stable release, but an issues has been detected and that's why the beta v1.13.7 has been released. Here's one of the local support websites where...

@Kinkeen You can try the FW release from this post for the MU-MIMO issue on BE800 v1.

@tplnkuser101 Firmware Version: 1.13.5 Build 240222 Rel.50991n(5553) apparently is not uploaded on some regional support websites. If you have troubles with this FW release check this thread on how...