@Modarlink The Dish V4 is paired with an equally new and improved Gen 3 Router According to its specifications Starlink Gen 3 router has the following parameters: Starlink Wifi Router Product...

@jolondon Did you follow these instructions for Starlink gen 2 ? They are quite straight-forward. The problem may have been caused by the AC1200 configuration - reset the AC1200 to its factory...

@mnewiraq The answer to your question would be pretty much similar to this one. Archer AX23 V1.20 and V1 are sharing the same firmware release.

@Vixh0 If that's the case then perhaps on your main router you can use a device isolation feature or similar to isolate the C80. Other than that, if you swap the location of your home network to be...

@Vixh0 You should use the C80 in roter mode if you want to isolate its guest wireless network from its main wireless network: Allow guest to access your local network should be unchecked:

@networkinguser If you have followed the instructions in the guide you mentioned then that's normal. Connect is not active since you've already set your DSL modem in bridge mode (modem-only mode)....