I'm trying to figure out how come I can't seem to add a switch ACL rule. I have 4 active ACL rules and when I try to turn on the 1st rule, I get the message - IP-Port Group cannot be applied in Switch

In DPI / Application control, we can currently only set Networks (ie, router interfaces) as targets for DPI. We should also be allowed to set IP groups. Switch only VLANs do not exist on the gateway,

Is there any way to use Discovery utility to change the controller IP of an already adopted remote router ? I have a router i want to change the controller IP of, which is in a locked room, 150 miles

So, i have tested and confirmed this on both 7206 v2 and 8411 with the new firmwares, testing the !ip_group function in gateway ACLs Scenario I have an IT vpn, and some remote site vlans that i want t

I have two Omada ER8411 v1.0 routers at separate, completely independent locations. Every few days, the router at each site stops forwarding traffic to the internal network. While I can still access t

I do not have anything connected to the WAN/LAN6 port but every few minutes it keeps telling it was up/down. Do i have a defective unit that needs to be replaced?