Hello, I have troubles connecting the AEP225-Outdoor wirelessly to the EAP225 V3 (latest firmware with mesh). Setup is as followes: - EAP225 V3 connected via cable to switch and via cabIe to ISP route

With Omada Controller 3.x it was possible to create a schedule which is bound to an AP instead of a wireless network. This way I turn off certain APs inside the house during the night without turning

Omada Controller v4.1.5 doesn't seem to have the Wifi signal strength of the connected clients like the older v3.2.10 had. I was wondering if we could get that added back in.

TP-Link could have made the upgrade process better. Referring to Omada Controller and EAP225/245. Omada Software Controller 3.2 does not work with EAP firmware 2.20. Omada SDN Controller 4.1 requires

Dumb question but I wanted to solicit any advice on mounting my CPE210 to an exterior wall. I see the instructions for mounting to a pole but that isnt an option. Is there a wall mount kit?

hi, I recently purchased 3 EAP245 (Model: EAP245(EU) v3.0 Firmware Version: 2.20.0 Build 20200423 Rel. 36779) access points and a 0C200 controller (1.2.3 Build 20200430 Rel.52621), but I cannot config