Just acquired a new TP-Link (ER606 Ver:2.6) Router with the intent of using it as a replacement for an aging router presently used to connect my network to the Internet. Followed instructions and conn

I have been through most menus in the controller and cannot find one about active DHCP leases. I have not used Omada DHCP much as for all my other networks thats handled by my Windows based DHCP serve

Hello All, I'm reading this Omada configuration guide -> Commonly Recommended ACL Configurations on Omada Switches In Introduction section it is said -> "Hosts in the same VLAN can communicate directl

As you can clearly see in my first pic, assigning MAC based IPs in OC200 with the ER707-M2 v1.20 router is definetly hit and miss. I have a very basic network and most clients do get the expected IP -

Hi, I'm looking for a way to change, saved by the device, URL address to controller. My ER605 is in remote location, already adopted, configured to reach out to the main controller via DDNS. I will ch

Background : We have omada controller(hardware), one POE switch, 10 APs. Purpose : We would like to enable "Port Mirror" on below switch, port 24 Problem : we are unable to select port 24 as "Port Mir