This version, 1.2.9, popped up as upgrade for 660HD. Some limited release notes. New Feature/Enhancement: 1. ⁠Supports IPv6. 2. ⁠Supports features for Ping, Traceroute, Packet Capture, Terminal, and D

Dear all I'm running the Omada software as docker container on my VPS server with the following specs: 1 vcpu 2 GB RAM 30G disk Up until 5.9.31 this was working pretty smooth and the CPU utilization w

Major issue with ER8411.... Was running fine for weeks then suddenly my internet dissapeared.... logged into my OC200 controller and saw that the ER8411 was now disconnected so i went to check it out

I'm wondering if it's possible to setup or provision Omada SDN and router/devices remotely? One time I mistakenly adopted a router with a newly setup Omada SDN, since it changed the IP address to the

I'm trying to setup a mesh between an EAP225 (EU, v4.0, firmware 5.1.0) and an EAP225-Outdoor (EU, v1.0, firmware 5.1.0). When testing everything, this just worked without problems. Then I found the "

Adoption loop After updating controller to 5.12.9 my router and switch are in a perpetual adoption loop. Network is fully functional. My temporary solution was to unplug the controller. Any thoughts o