Hi, My AP is broken, it respond to ping but cannot be accessed via HTTP. I upgrade firmware using tftp method but the problem is the same. I am looking for an SPI image firmware to write it using an s

Hi, I have a site with a local controller and three EAP660 that I have set up on April 18th (about 2 weeks ago). Everything was working fine, but then yesterday at 16:00, one of the three APs dropped

Hey All, The configuration below is to show how to use an Omada Switch as a DHCP Server with DHCP Pools, and DHCP Reservation to support Omada Layer 3 Switch Configuration. I have detailed the steps a

I recently bought this ER605 router, the main objective is for it to balance the load of my two internets (WAN's) as well as correct it in case of failures. apparently it is working normally, however

So I followed the guide here: https://www.reddit.com/r/TPLink_Omada/comments/16tj25p/wireguard_vpn_on_er605_v2_with_omada_a/ I successfully set up a wireguard vpn that my laptop (kubuntu) can connect

This Article Applies to: EAP620 HD_V3 | EAP660 HD_V1 | Fully Adapted to Omada SDN Controller v5.14 Release Notes: New Feature/Enhancement: 1. Add support to display the configuration synchronization s