Hello, I'm trying to setup the switch so that only a single MAC addresses can connect to a single port. Could you tell me how I can do this, or point me to a guide? Thanks, Luke

I am having an issue with my home network, where i have a main router, connected to the internet and 2 x TPlink EAP115 AP's. Both AP's are connected via LAN cable. One is situated in the passage and t

I am trying to Run a class B network (192.168.0.1/23) using ER605 (TL 605) VPN Router with mix of Static and DHCP IPs. The DHCP IP range is 192.168.0.100 to 192.168.1.150. Rest of the IPs are in stati

I have the ER605 trying to work as a router off the SB8200 cable modem. It goes down daily, and struggles to come back up without a full cycle reset. I recently enabled the 2nd wan port, Wan/Lan1, and

I have two identical ER605V1 routers. Both with the identical beta firmware load, both running off Docker based Linux Controllers which are both 5.9.31. Both have dynamic DNS setups at freedns-afraid-

This Article Applies to: ER605 v1 _1.3.0_Build 20230511 (Adapted to Omada SDN Controller v5.8) Release Notes: New Feature/Enhancement: 1. Add stateful ACL. 2. Add mDNS Repeater . 3. Add support for se