Whenever I start the controller it will provision the router and cause downtime in the process. How can I prevent this from happening? I read that with newer versions of the controller this is solved,

Any change I make to my configuration requires a 'force provision' of my ER 605 router. For instance, I change the DHCP range, or the online detection interval and as soon as I save I get a alert in t

Hello, Vlan's are broken , devices do not seem to get IP address. same with clients on SSID's , connect to Wifi do not get IP address edit: you can change the Ip -range etc... 's on the main lan , but

Hello, I established an IPSEC VPN between two remote sites. (10.239.100.0 and 128.1.1.0) The VPN works but I can't set up an IP translation. Site A's local network is 192.168.15.0, but this network

Despite a good signal strength, my client failed to obtain an IP address

I have setup a new WLAN (OSA_Residents) for my residents (apartments) - this was created as PPSK without radius. I then created a PPSK profile and added 2 'users' to the profile both on their own VLAN