We have multiple EAP225 that run our application without issue. when we run the same application through any EAP610, our connected client devices stop receiving UDP broadcast at approximately 4 minute

I have a NAS previously assigned to a fixed IP address of 10.10.10.100. I changed the NAS IP address to 10.10.10.20. I did this by changing the NAS' static IP address to 10.10.10.20 and enabled fixed

Been meaning to post about this for a while, but, busy. When I change my network IP range when using an OC200, it would need a manual power cycle to grab the new IP scheme and come back online. Anyone

Updated my controller last night, now the ER605 gets stuck in provisioning/adopting. Hard reset the ER605 and manually updated the firmware, and it still does the same thing... Please help!

If anyone is struggling with a free dynamic service then I was able to successfully use dynu dns after contacting their support. On the most recent firmware select the custom tab. In the GENERAL secti

I have encountered a strange issue with a Omada network I am managing. This problem occurs rarely. Has anyone else seen this problem or have any idea why it is happening? Network layout: Provider’s ro