I've just installed my second Tapo TC40 camera which is OK but when I try to set the pan/tilt default view I get a message saying "operation failed, try again later". It's the same with setting sensit

I have configured the Tapo H500, but it seems that there are still quite some bugs: I'm not able to change Location. When I try to save, it says 'Error. Please try again later'. Because of this issue,

Hello, four of my plugs (P110 V1) updated to version 1.3.4 Build 250402 a few days ago. Since then, there have been major problems. The humidity sensor controls the on/off of these plugs via the hub a

Camera would not display and video footage or wasn't recording anything for a few days. It also had a firmware update to 1.3 available which I tried to install without any luck. I tried to remove the

Hello, I have more than a dozen different smart plugs 115,110, 110M. In the past only two of them are nor accessible, but after moving the python code to RaspBerry Pi Zero, all show up this 'not macht

Hello, I'm wondering when the update to enable the 24/7 capture feature on the C460 solar kit will be released here in the UK? I'd also like to know if this feature will be coming to other solar power