This Article Applies To Tapo H100 - Firmware 1.5.23 and earlier versions Description To create a local smart automation, your setup must meet the following requirements: 1. Supported Firmware: The Tap

NOTE: This affects both HS100 and KP105, but I have seen it mostly on HS100 I have been using Kasa smart plugs since 2019 and have generally found them to be quite reliable. However over the last mont

If the power or WiFi goes out and after reconnecting, the device should check the status according to the set automation. That is, if the socket is supposed to be turned off, then it should turn off a

Has anyone else experienced this? I’ve noticed something unusual and I’m wondering if it’s just me or a possible firmware bug that could be addressed in an update. Exactly 4 seconds into any video cap

I have recently bought 4 C425 cameras along with A201 solar panels separately instead of a kit. The retailer website said I can have unified look or separate installation options. But camera mount is

I have just installed an H500 hub but it will not connect to my existing cameras, it finds them ok, but says firmware not up todate . Yet all cameras report that their firmware is up to date. My camer