Does not recognize LAN after being disconnected/connected from power line.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Does not recognize LAN after being disconnected/connected from power line.
Model : Archer MR200
Hardware Version :
Firmware Version : 1.2.0 0.9.1 v004a.0 Build 170927 Rel.58861n
ISP : vodafone
Does not recognize LAN after being disconnected/connected from power line.
I need to do it with a device wich disconnects the router from power line an reconnects it again, in order to force the router to connect internet via 3G in a rural area when signal is ussually lost.
The router manages agricultural applications and ip cameras.
Till I unplug/plug the ethernet cable it does not detect the cable. Normally, is far enough the router to do it, so I lose connection with the applications.
This question worked fine with very lod routers !
Any suggestions?
Hardware Version :
Firmware Version : 1.2.0 0.9.1 v004a.0 Build 170927 Rel.58861n
ISP : vodafone
Does not recognize LAN after being disconnected/connected from power line.
I need to do it with a device wich disconnects the router from power line an reconnects it again, in order to force the router to connect internet via 3G in a rural area when signal is ussually lost.
The router manages agricultural applications and ip cameras.
Till I unplug/plug the ethernet cable it does not detect the cable. Normally, is far enough the router to do it, so I lose connection with the applications.
This question worked fine with very lod routers !
Any suggestions?