Archer VR600v & VR200v static routing not working properly
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR600v & VR200v static routing not working properly
Model :
Hardware Version :
Firmware Version :
ISP :
I have my LAN connected to another sites LAN thru OpenVPN using a Raspberry Pi running as OpenVPN-Client. Therefore I have to route all traffic adressed to the IP-range of the other LAN permanently to the Raspberry's IP. Thats what static routing is for. However, with both, the VR200v and the VR600v, this does not work as intended. Traffic from the internal LAN to a destination in the other LAN is routed correctly. However, traffic from the remote-LAN to a destination in the LAN of the Archer get lost. Since my setup works fine with other brands routers, this obviously is a bug in the TP-Link firmware. I contacted TP-Link support one week ago, with no reaction for now.I would've attached a screenshot of my settings to show it clear for anybody wanting to assist here, unfortunately this board software does not work troublefree too, I cannot attach a picture to this post (nothing happens by clicking on "Attachments")
Hardware Version :
Firmware Version :
ISP :
I have my LAN connected to another sites LAN thru OpenVPN using a Raspberry Pi running as OpenVPN-Client. Therefore I have to route all traffic adressed to the IP-range of the other LAN permanently to the Raspberry's IP. Thats what static routing is for. However, with both, the VR200v and the VR600v, this does not work as intended. Traffic from the internal LAN to a destination in the other LAN is routed correctly. However, traffic from the remote-LAN to a destination in the LAN of the Archer get lost. Since my setup works fine with other brands routers, this obviously is a bug in the TP-Link firmware. I contacted TP-Link support one week ago, with no reaction for now.I would've attached a screenshot of my settings to show it clear for anybody wanting to assist here, unfortunately this board software does not work troublefree too, I cannot attach a picture to this post (nothing happens by clicking on "Attachments")
