Openvpn problem
I used the setup from https://www.tp-link.com/us/support/faq/1237/ and when I try to connect with Tunnelblick it says my computers public ip address has not changed and it is still xx.xxx etc. If I connect the text in the Tunnelblick window turns green and I am connected. If I bring my computer somewhere else it cannot connect to the server. The config txt file has an internal ip address (192.xxx). If I try to change it to my computers IP address when I am connected to the router it cannot find the server. How do I fix this?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
If you aimed to connect your computer to the OpenVPN server, please follow the instruction below:
https://www.tp-link.com/us/support/faq/1239/
Meanwhile, may I know which setup you get stuck? Please show us a picture of it also.
Thanks in advance, and have a nice day.
- Copy Link
- Report Inappropriate Content
I did follow the instructions and I can install the openvpn and when I connect at home everything is OK. But when I try to connect through my phone 4G or through the wifi at work the Tunnelblick can not connect to the server. The timer runs out. I am on a mac
- Copy Link
- Report Inappropriate Content
And when I disconnect (still at home) my internet connection does not work even though it is connected to the router. I have to turn wifi off an on again to access internet.
And when I connect with Tunnelblick I get a warning:
This computer's public IP address was not changed after connecting to OpenVPN-Config-Archer_C5400 (4). It's still xx.xxx.xxx.xx.
This may mean that your VPN is not properly configured.
- Copy Link
- Report Inappropriate Content
Hi,
Our engineer will email you later, if you are willing to do further analysis, please check your inbox.
Please wait a while until they reach out to you.
Thanks for your understanding and cooperation in advance, and have a nice day
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1753
Replies: 4
Voters 0
No one has voted for it yet.