Archer C6 2.4G band stops working, disable then enable restores
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Recently purchased Archer C6 Router running the latest firmware. On 4 occasions the 2.4G WiFi band has stopped working, devices can connect to it but get no network access. Disabling and enabling the 2.4G band on the admin interface restores the connectivity, the 5G band is not affected, a device connected to it is used to reset the 2.4G band.
I used the chat support service to discuss the issue and the suggestion was to change from automatic to a fixed channel for the 2.4G band, this appeared to resolve the issue but it has happened again today, a phone which only works on 2.4G was showing the WIFI as access denied.
is there anything else I can do to resolve this issue.
StuartP
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@Kubas I've also tried disabling the guest network and so far after 2 days, 2.4ghz still online and no crashes.
- Copy Link
- Report Inappropriate Content
Can you tell us how you solved it? Thanks
- Copy Link
- Report Inappropriate Content
Hi, very nice. If you have it stable let it work.
It is still unclear for me what is causing this. But i have never seen this issue coming back,when i get the C6 stable, but i can force it by enabling the 2.4 GHz Guest and set the wireless under stress, then it will comeback .in a day.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
If you want a firmware like 1.2.x you should try beta 1.3.1. The wireless changes they made were reverted in 1.3.1 😉.
- Copy Link
- Report Inappropriate Content
Thanks for the heads up. Where can I get my hands on a 1.3.1 beta firmware?
aTOMic1971 wrote
If you want a firmware like 1.2.x you should try beta 1.3.1. The wireless changes they made were reverted in 1.3.1 😉.
- Copy Link
- Report Inappropriate Content
aTOMic1971 wrote
Hi all,
has anyone with this issue tried firmware BETA 1.3.1 yet ?
It disables the hidden OneMesh Network. This issue began with 1.3.0 and the OneMesh update.
So if you don`t need OneMesh it is worth to try..., maybe it will cure your C6 until this is fixed.
Direct Download Link Beta 1.3.1 C6 EU V2
- Copy Link
- Report Inappropriate Content
Thanks. I will flash this and see how it goes. At this point, I honestly feel like dumping TP Link and going back to Netgear. They're way more competent than these TP Link idiots.
- Copy Link
- Report Inappropriate Content
@RedIndianRobin From 1.2.x I have installed openwrt and then gone back to 1.2.x using tftp. You just follow openwrt instructions. But in wrt 5ghz is not stable enough yet.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 5
Views: 123086
Replies: 580
Voters 3
